MATERIAL SAFETY DATA SHEET

HILTI, INC.:
P.O. Box 21148
Tulsa, OK 74121
Ph: 1 800 879 6000
Emergency No.: 1 800 879 4444

PRODUCT NAME: CA 3600 Solvent-Free High Performance Construction Adhesive

DESCRIPTION: Polyvinyl acetate emulsion

INGREDIENTS AND EXPOSURE LIMITS

PEL = OSHA Permissible Exposure Limit. TLV = ACGIH Threshold Limit Value. These are 8 hour time-weighted averages unless otherwise indicated by "C" (Ceiling) or "STEL" (Short Term Exposure Limit). NE = None Established. NA = Not Applicable.

PHYSICAL DATA

APPEARANCE AND ODOR: Light beige paste. Mild odor.	pH: 4.0 - 6.0
BOILING POINT: Approx. 212° F	MELTING POINT: Not Determined
VOC CONTENT: 5.1 g/l	VAPOR PRESSURE: Not Determined
EVAPORATION RATE: <1 (n-butyl acetate = 1)	VAPOR DENSITY: > 1 (air =1)
SOLUBILITY IN WATER: Miscible	SPECIFIC GRAVITY: 1.45

FIRE AND EXPLOSION HAZARD DATA

FLASH POINT: None FLAMMABLE LIMITS: Not Applicable

EXTINGUISHING MEDIA: CO₂, Dry Chemical, Foam, Water

SPECIAL FIRE FIGHTING PROCEDURES: A self-contained breathing apparatus should be worn when fighting fires involving chemicals.

UNUSUAL FIRE AND EXPLOSION HAZARDS: None known. Thermal decomposition products can be produced under fire conditions. See below.

REACTIVITY DATA

INCOMPATIBILITY: Strong acids and bases STABILITY: Stable.

HAZARDOUS DECOMPOSITION PRODUCTS: Thermal decomposition can yield oxides of carbon as well as acrid and irritating fumes.

HAZARDOUS POLYMERIZATION: Will not occur.

CONDITIONS TO AVOID: Avoid temperature extremes; i.e. below freezing and above 100° F.

HEALTH HAZARD DATA

KNOWN HAZARDS: Can cause dizziness and irritation. Possible sensitizer in rare cases.

SIGNS AND SYMPTOMS OF EXPOSURE: EYES - can cause irritation. SKIN - Prolonged and repeated contact can cause irritation. INHALATION - No effects are expected under normal conditions of use. INGESTION - Effects of ingestion have not been determined; no effects anticipated. Not considered to be a potential route of exposure.

PRIMARY ROUTES OF EXPOSURE: Inhalation.

CARCINOGENICITY: IARC classifies crystalline silica as a Gp IIA carcinogen based upon inhalation of respirable dust. This product does not pose a dust hazard; therefore, this classification is not relevant / applicable.

MEDICAL CONDITIONS AGGRAVATED BY EXPOSURE: Eye, skin, and respiratory conditions.

EMERGENCY AND FIRST AID PROCEDURES

EYES: Flush with plenty of water. Call a physician.

SKIN: Wash with soap and water.

INHALATION: Move victim to fresh air. Call a physician if symptoms persist.

INGESTION: Seek medical attention. Do not induce vomiting unless directed to by a physician. Never give anything by mouth to an unconscious person.

OTHER: Referral to a physician is recommended if there is any question about the seriousness of the injury/exposure.

CONTROL MEASURES AND PERSONAL PROTECTIVE EQUIPMENT

VENTILATION: General (i.e., natural or mechanically induced fresh air movements that maintain vapor concentrations below recommended exposure limits).

EYE PROTECTION: Not required, however, safety glasses should be worn in most industrial settings.

SKIN PROTECTION: Cloth or impervious gloves recommended.

RESPIRATORY PROTECTION: None normally required. Where ventilation is inadequate to control vapors or if discomfort occurs, use a NIOSH-approved respirator for organic vapors. . Never enter a confined space without an appropriate air supplied respirator.

PRECAUTIONS FOR SAFE HANDLING AND USE

HANDLING AND STORING PRECAUTIONS: Store in a cool, dry area. Keep from freezing. Avoid prolonged or repeated contact. Use with adequate ventilation. Always wash thoroughly after handling chemical products.

SPILL PROCEDURES: Wipe up spilled material with a cloth and place in a container for proper disposal. Not considered a hazardous waste according to EPA definitions.

REGULATORY INFORMATION

HAZARD COMMUNICATION: This MSDS has been prepared in accordance with the federal OSHA Hazard Communication Standard.

HMIS CODES: Health 1, Flammability 0, Reactivity 0, PPE B

DOT SHIPPING NAME: Not regulated

TSCA INVENTORY STATUS: Chemical components listed on TSCA inventory.

SARA TITLE III, SECTION 313: This product contains <0.25% vinyl acetate, CAS 108-05-4 (as residual monomer) which is subject to reporting under Section 313 of the Superfund Amendments and Reauthorization Act of 1986 and 40 CFR Part 372.

WASTE DISPOSAL METHODS: Consult with regulatory agencies or corporate personnel for disposal methods that comply with local, state, and federal health and environmental regulations.

HEALTH / SAFETY CONTACTS:
Steve Gerrard (x6309)
Jerry Metcalf (x6704)

The information and recommendations contained herein are based upon data believed to be correct; however, no guarantee or warranty of any kind expressed or implied is made with respect to the information provided.